Semiconductor · UPW

265nm UVC for semiconductor UPW loops

Trace microbes and pipe biofilm in UPW distribution can drive TOC spikes and yield loss. Aqua Lux Hyper Flux™ UVC 740 delivers mercury-free, non-thermal 265nm LED disinfection with traceable dose on critical paths.

Pain point

In UPW distribution loops, bacteria can form biofilm on pipe walls; release events often show up as TOC excursions. Chemical dosing may add contamination and residual-management cost, and side-stream filters do little against attached film.

Unplanned downtime is expensive—process and quality teams need auditable microbial-control evidence, not just installed hardware.

Approach

Deploy Hyper Flux™ UVC 740 (Ø46×744 mm / 265nm) on critical distribute or reclaim paths for physical disinfection, with flow×intensity feedback to hold target dose.

Bypass or inline; parallel reactors for higher flow
Traceable run data (dose-related metrics, flow, alarms) for process audits
Mercury-free, power-tunable LEDs aligned to site UVT and flow

What to verify

Published wavelength and chamber geometry (265nm, Ø46×744 mm)
Per-unit Standard/Boost dose and 3S cumulative dose for sizing
Site performance depends on flow and UVT—engineering assessment first

Evaluate your UPW loop

Share design flow, pipe size, water quality / UVT, and P&IDs. Or start with the use-case summary or FAQ.